Drug calculations for nurses: the formulas, worked examples and 15 practice questions
Understand the three formulas, the rounding rules and the common mistakes, then try practice questions with full working.
On this page
Drug calculations for nurses use three formulas. For a dose, divide what you want by what you've got and multiply by the volume it comes in. For an infusion, divide the volume by the time in hours to get mL/hr, or multiply the volume by the drop factor and divide by the time in minutes to get drops per minute. Convert everything to the same unit first and round only at the end. Before you can register, you need to pass a medicines calculation assessment at 100%, so this guide works through each type and finishes with questions to try.
What drug calculations does a student nurse need, and why 100%?
Your university will test medicines calculations at points through your course, and you need to pass at 100% by the end. The NMC's programme standards require a health numeracy assessment, covering nursing proficiencies and the calculation of medicines, that must be passed at 100%. The reason is practical. One misplaced decimal point gives a patient ten times the dose, or a tenth of it.
Most tests are built from six types of question. Which ones appear, and whether you can use a calculator, depends on your university and your field of nursing. Your module handbook will say.
| Calculation | Formula | Answer in |
|---|---|---|
| Unit conversion | × or ÷ 1,000 | g, mg, micrograms |
| Tablets | want ÷ got | tablets |
| Liquids and injections | want ÷ got × volume | mL |
| Weight-based dose | dose per kg × weight | mg |
| Infusion rate | volume ÷ hours | mL/hr |
| Drip rate | volume × drop factor ÷ minutes | drops/min |
Source: RCN Safety in numbers. Last checked: 17 November 2026.
The RCN's free Safety in numbers resource covers each type. It also suggests making a rough estimate before you calculate, so a wrong answer stands out when you see it.
How to convert grams, milligrams and micrograms
Each step between these units is a factor of 1,000. Going to a smaller unit, multiply by 1,000. Going to a larger unit, divide by 1,000. In practice, you move the decimal point three places.
| From | To | Do this |
|---|---|---|
| grams (g) | milligrams (mg) | × 1,000 |
| milligrams | micrograms | × 1,000 |
| micrograms | milligrams | ÷ 1,000 |
| milligrams | grams | ÷ 1,000 |
| litres (L) | millilitres (mL) | × 1,000 |
Source: RCN Safety in numbers. Last checked: 17 November 2026.
Worked example (3 marks)
Three worked through:
- 1.5 g to mg: 1.5 × 1,000 = 1,500 mg.
- 0.25 mg to micrograms: 0.25 × 1,000 = 250 micrograms.
- 750 micrograms to mg: 750 ÷ 1,000 = 0.75 mg.
Before you use any formula, put the prescribed dose and the stock strength into the same unit. Converting to the smaller unit is usually easier, because it clears away decimals.
Write units the way a prescription does. Prescribing guidance based on the BNF says doses under 1 g are written in milligrams (500 mg, not 0.5 g), and that micrograms and units are written out in full. A handwritten "µg" can be misread as "mg", which is a thousandfold error. NHS prescription standards also put a zero before a lone decimal point: 0.5 mL, never .5 mL. Leave off trailing zeros too, so 5 mg rather than 5.0 mg, which could be read as 50 mg.
Tablets and liquid medicines: what you want over what you've got
One formula covers tablets, oral liquids and injections:
Dose = what you want ÷ what you've got × what it's in
What you want is the prescribed dose. What you've got is the strength of the stock. What it's in is the volume that strength comes in: 1 for a tablet, or the number of mL for a liquid or an injection.
Tablets first.
Worked example (1 mark)
Paracetamol 1 g is prescribed and the stock is 500 mg tablets.
- Match the units: 1 g = 1,000 mg.
- Divide: 1,000 ÷ 500 = 2.
- Multiply by what it's in: 2 × 1 = 2 tablets.
Now a liquid.
Worked example (1 mark)
Amoxicillin 125 mg is prescribed and the stock is 250 mg in 5 mL.
- Divide: 125 ÷ 250 = 0.5.
- Multiply by the volume: 0.5 × 5 = 2.5 mL.
You want half the strength in the stock, so half of 5 mL makes sense. That quick check catches most slips.
Weight-based doses add one step at the start. Multiply the dose per kilogram by the patient's weight, then use the same formula.
Worked example (1 mark)
For 15 mg/kg in a child weighing 20 kg, the dose is 15 × 20 = 300 mg. From a stock of 120 mg in 5 mL, that's 300 ÷ 120 × 5 = 12.5 mL.
If a tablet answer isn't a whole number or a half, recheck your units before anything else. Only halve a tablet that is scored and suitable for splitting.
IV infusion rates in mL/hr and drops per minute
An infusion pump runs in millilitres per hour. A gravity drip has no pump, so you count drops per minute, using the drop factor printed on the giving set packet.
- mL/hr = volume (mL) ÷ time (hours)
- drops per minute = volume (mL) × drop factor ÷ time (minutes)
These match the formulas in the RCN's Safety in numbers. Gloucestershire Hospitals' practice papers give the usual drop factors: 20 drops per mL for a standard giving set and 15 drops per mL for a blood giving set. A test question will normally tell you which one to use.
Worked example (2 marks)
Here is 1,000 mL of sodium chloride 0.9% over 8 hours, worked both ways.
- mL/hr: 1,000 ÷ 8 = 125 mL/hr.
- Drops per minute: change 8 hours to 480 minutes.
- 1,000 × 20 = 20,000, then 20,000 ÷ 480 = 41.67.
- Round to the nearest whole drop: 42 drops per minute.
Worked example (1 mark)
Some prescriptions give a dose per hour instead, such as 2 mg/hr from a syringe holding 50 mg in 50 mL. Use the want-over-got formula: 2 ÷ 50 × 50 = 2 mL/hr.
Rounding rules for drug calculations
| Answer type | Usual rounding | Why |
|---|---|---|
| Drops per minute | Whole number | You can't count part of a drop |
| Pump rate (mL/hr) | As the question says, often 1 decimal place | Matches what the pump accepts |
| Tablets | Whole or half | Only scored tablets can be split |
| Liquids (mL) | As the question says | Matches the syringe markings |
Source: RCN Safety in numbers; your test's own instructions always come first. Last checked: 17 November 2026.
Round once, at the end. If you round 41.67 to 41.7 partway through a longer question and then multiply, the error grows with every step.
Common mistakes that fail a drug calculation test
At 100%, one slip is a fail. Most slips fall into a few familiar patterns:
- Mixed units. Dividing 0.5 g by 250 mg as written gives 0.002, which means nothing. Convert first.
- Moving the decimal point the wrong way, or by two places instead of three. Ask whether the number should get bigger or smaller.
- Hours and minutes swapped. Drops per minute needs the time in minutes; mL/hr needs it in hours.
- Rounding too early, or giving drops per minute as a decimal.
- Answers with no unit. Write it every time: 2.5 mL, 42 drops/min.
- A calculator keying error that you don't notice because you skipped the estimate.
- Misreading the prescription. A daily dose given in divided doses must be split before you work out each one.
The fix for nearly all of these is one habit. Write each step down with its units, then compare your final answer with your estimate. If you'd like a second pair of eyes, Medly's AI tutor can go through your working line by line and show you which step went wrong.
Drug calculation practice questions with answers
Five questions, covering liquid doses, a weight-based dose and both kinds of infusion rate. Work each one out on paper before you open the answer. The full set of 15, with answers, is on a printable sheet: download the practice sheet.
Question 1: (1 mark)
Digoxin 62.5 micrograms is prescribed. The stock is an oral solution containing 50 micrograms in 1 mL. What volume do you give?
Answer
- The units already match: both are in micrograms.
- What you want ÷ what you've got = 62.5 ÷ 50 = 1.25.
- Multiply by what it's in: 1.25 × 1 mL = 1.25 mL.
The answer is more than 1 mL because you want more than 50 micrograms. If you got less than 1 mL, you divided the wrong way round.
Question 2: (1 mark)
Amoxicillin 0.5 g is prescribed. The stock is an oral suspension containing 250 mg in 5 mL. What volume do you give?
Answer
- Match the units: 0.5 g × 1,000 = 500 mg.
- What you want ÷ what you've got = 500 ÷ 250 = 2.
- Multiply by what it's in: 2 × 5 mL = 10 mL.
Most lost marks here come from skipping the conversion and working with 0.5 and 250.
Question 3: (1 mark)
Paracetamol 15 mg/kg is prescribed for a child weighing 18 kg. The stock is an oral suspension containing 120 mg in 5 mL. What volume do you give? Give your answer in mL to 2 decimal places.
Answer
- Work out the dose: 15 mg × 18 kg = 270 mg.
- What you want ÷ what you've got = 270 ÷ 120 = 2.25.
- Multiply by what it's in: 2.25 × 5 mL = 11.25 mL.
Estimate to check: 240 mg would be 10 mL, so 270 mg should be a little more than 10 mL.
Question 4: (1 mark)
500 mL of sodium chloride 0.9% is to be given over 6 hours using an infusion pump. What rate should you set, in mL/hr? Give your answer to 1 decimal place.
Answer
- mL/hr = volume ÷ time in hours.
- 500 ÷ 6 = 83.333...
- Rounded to 1 decimal place: 83.3 mL/hr.
Question 5: (1 mark)
1,000 mL of sodium chloride 0.9% is to be given over 6 hours using a giving set that delivers 20 drops per mL. How many drops per minute is that?
Answer
- Change the time to minutes: 6 × 60 = 360 minutes.
- Volume × drop factor = 1,000 × 20 = 20,000 drops.
- Divide by the time in minutes: 20,000 ÷ 360 = 55.56.
- Round to the nearest whole drop: 56 drops per minute.
Using 6 instead of 360 gives 3,333 drops per minute, which an estimate would catch straight away.
To practise more calculations like these, Medly can set you new questions of each type and talk you through the method whenever your answer doesn't match.
Frequently asked questions
What is the formula for drug calculations in nursing?
For tablets, liquids and injections, use what you want ÷ what you've got × what it's in. For infusions, mL/hr is volume ÷ hours, and drops per minute is volume × drop factor ÷ time in minutes.
What is the pass mark for a nursing drug calculation test?
100%. The NMC requires a health numeracy assessment, including the calculation of medicines, to be passed at 100% by the end of your programme. Your university decides when you sit it and how many attempts you get.
Can you use a calculator in a nursing drug calculation test?
It depends on your university. Some allow a basic calculator and others test some or all questions without one, so check your module handbook and practise both ways.
How do you round drops per minute?
To the nearest whole number, because you can't count part of a drop. Keep the full figure through your working and round only at the final step.
Is the nursing drug calculation test hard to pass?
The maths itself is GCSE level: multiplying, dividing and moving decimal points. What makes it demanding is the 100% pass mark, so regular practice and a fixed method for checking each answer matter more than speed.
Do nursing applicants need to know drug calculations?
No. Some universities set a numeracy test at interview, but these check general arithmetic, and you learn drug calculations on the course. While you're applying, the personal statement and the 6 Cs deserve more of your time.